![Global metis Micro Скачать руководство пользователя страница 10](http://html.mh-extra.com/html/global/metis-micro/metis-micro_installation-and-user-manual_2232503010.webp)
Metis micro user manual v1.6
10
4
4
4
4 –
–
–
– INSTALLATION
INSTALLATION
INSTALLATION
INSTALLATION
4.
4.
4.
4.1
1
1
1 Connecting a power supply
Connecting a power supply
Connecting a power supply
Connecting a power supply
me
me
me
me
tis
tis
tis
tis
Micro
Micro
Micro
Micro is powered by an external power supply. The input voltage is +
+
+
+12…+24VDC
12…+24VDC
12…+24VDC
12…+24VDC.
The device’s normal power consumption is approximately 40mA and momentarily (during
a SMS send) it can rise up to approximately 400mA.
*
**
*NOTE
NOTE
NOTE
NOTE!
! !
! The upper limit of the supply voltage
The upper limit of the supply voltage
The upper limit of the supply voltage
The upper limit of the supply voltage (+24VDC)
(+24VDC)
(+24VDC)
(+24VDC) is the absolute maximum value.
is the absolute maximum value.
is the absolute maximum value.
is the absolute maximum value.
Make sure that this limit is not exceeded. In systems that utilize 24V batteries have a typical
Make sure that this limit is not exceeded. In systems that utilize 24V batteries have a typical
Make sure that this limit is not exceeded. In systems that utilize 24V batteries have a typical
Make sure that this limit is not exceeded. In systems that utilize 24V batteries have a typical
char
char
char
charging voltage of 27
ging voltage of 27
ging voltage of 27
ging voltage of 27----28VDC.
28VDC.
28VDC.
28VDC.
4.
4.
4.
4.2
2
2
2 Start
Start
Start
Start----up
up
up
up
Connect the power supply. me
me
me
me
tis
tis
tis
tis
Micro
Micro
Micro
Micro automatically connects to the GSM-network. This
takes approximately a minute during which the red ”wait/fault” led is constantly lit. When
the device is ready and fully operational the green led is constantly lit.
If the device has any phone numbers stored, the device sends information about the start-
up to these numbers (including any possible alarms).
The red ”alarm” light indicates an alarm. When testing the device remember that the
inputs may have delays and response times set – meaning that the alarms may not be sent
immediately.
4.
4.
4.
4.3
3
3
3 Inputs
Inputs
Inputs
Inputs
Connect sensors/detectors to the inputs according to the instructions (see 8 – Connectors).
Factory setting for inputs is armed. All sensors using entry/exit delays must be connected
to input 1.
Arm/disarm –control is possible to do by phone call only if the setting has been activated
(see 6.9 General settings)
Input 1 can be configured with an entry / exit delay. This represents the time user has to
disarm the system after entering the premises under surveillance and exit after arming the
system (see 6.4 –Input settings).