Assembly Instructions
3
Electric Convection Heater
OPERATING INSTRUCTIONS
Operation
1. Plug the heater cord into a standard
grounded 120-volt AC outlet. Operate
heater in the upright position with
rubber feet on the floor. The plug must
fit tightly into outlet. A loose fit will
cause overheating and damage to the
plug. During normal use, the plug may
feel warm.
2. Turn heat selector knob to the “LOW”
(600W), “MED” (900W) or “HIGH”
(1500W) setting.
3.
Turn the thermostat knob clockwise
(right) until knob stops. The heater will
begin heating. At “LOW” (600W) the fan
does not operate. At “MED” (900W) and
“HIGH” (1500W) settings, the fan will
blow warm air.
4. When the room temperature reaches the
desired comfort level, slowly rotate the
thermostat knob counterclockwise (left)
until the heater shuts off. At this setting,
the heater will automatically cycle on
and off to maintain this temperature.
NOTE:
Do not force the knob beyond
its normal stopping position. Only minor
adjustments to the thermostat should be
necessary to maintain the desired comfort
level. Turning clockwise will increase the
room temperature and counterclockwise
will decrease the temperature.
5.
To conserve energy, the heater may
operate at lower wattages by turning
heat selector knob to the “LOW” (600W)
or “MED” (900W) settings.
6. When heater is not needed, turn control
knob to the “OFF” position. Then
remove the plug from outlet.
7. This heater is equipped with Tip-over
switch. When the heater is tipped over,
the unit will shut off.
To Reset Over-Temperature Control
This heater is equipped with a built-in
over-temperature safety switch that will
turn the heater off if overheating occurs. To
reset the heater, turn control to OFF, then
remove the plug from outlet. Wait until the
heater has cooled and the condition that
caused the overheating is corrected. The
safety switch will then be reset.
Before cleaning, make sure that:
1. The heater is turned OFF.
2. Disconnect power supply at source by removing plug from power outlet.
3. Your heater is now ready for cleaning.
Regular Cleaning:
1. Do not use cleaning products or chemicals to clean the unit.
2. Dust inside the heater can be removed using a vacuum cleaner with
a crevice tool attachment.
3. To clean enclosure use a clean, soft lightly dampened cloth to gently wipe dirt from the
surface of the unit. Be careful not to wet the heating element and switches. Allow the
unit to dry completely before using it.
CAUTION: do not allow water to run into the interior of the heater as this could
cause a fire, an electric shock hazard and damage the unit.
1. Perform the cleaning procedures described in “Cleaning/Maintenance”.
2. Wipe all parts until dry.
3. Pack the heater in a plastic bag and store in a cool, dry place.
IMPORTANT
THIS HEATER IS FOR FLOOR USE ONLY.
This heater comes with a grounded (3 blade) plug for 110-120 volts AC.
The grounded plug must be used with a grounded outlet. Do
not use an adapter in a 2-slot wall outlet unless the ground plug
of the adapter properly connects to a building ground. Using
heater without properly grounded outlet or adapter could result
in an electric shock hazard.
SPECIFICATIONS
CLEANING AND MAINTENANCE
STORAGE
Model Number
653557
Power Supply
120 volts AC, 60Hz
Power Consumption
600/900/1500W
Grounding
Pin
A
B