1.4
OVERHEAD RIGGING
This requires a high measure of experience. This means:
• Knowledge in the calculation to the definition of the load-capacity.
• Knowledge of the used installation material.
• Regular safety inspections of the used material and the device
If you lack these qualifications, do not attempt the installation yourself, but instead use a professional
structural rigger. Injuries and/or damages to property can be the result of an improper installation!
• The device must never be fixed swinging freely in the room and has to be installed out of reach of
people.
• Before rigging make sure that the installation area can hold a minimum point load of 10 times the
installation‘s weight. (Note: The maximum load of the truss can be found labeled on every GLOBAL
TRUSS trusses; Furthermore you can also download our free GLOBAL TRUSS TOOLBOX application for
your smartphone)
At overhead rigging the trussing must always be safeguarded with a safety-rope. This must satisfy the
following conditions:
• Interpretation for at least the 12-fold weight of the fixture
• only quick link with screw cap
• maximum drop distance 20cm
• after single load due to fall or damage this may not be used any more
1.5
RESPONSIBILITES
• Always make sure with trussing constructions and/or buildings that all local authority regulations are
adhered to.
• The characteristics of a structure made from GLOBAL TRUSS components will change by making even
the smallest change of parts and therefore a structure should be re-tested as described above after
such changes.
• Depending upon your local situation, it is possible that further regulations must be considered. You
should be aware of these and adhere to them accordingly.
• We would like to draw your attention to the fact that you are responsible for the trussing system provi
ded by you, i.e. you must take care for it that the static regulations and all other regulations are kept.
You are also responsible for any third parties used for rigging purposes and should send them any co
pies of mounting instructions, official approvals and load weight charts.
• You are also responsible for third party riggers, to send them a copy of the mounting instructions, the
statistical removal and the official approvals.
• Please use only original GLOBAL TRUSS products. It can easily be identified by the engraved GLOBAL
TRUSS Logo and the TUV approval label which can be found on every truss.
• The truss construction has to be properly earthed.
www.dq.com.au