2
Hand Crank Adjustable Workbench
1) Lay out all components and hardware to ensure that you have all the
components and hardware. Fully separate the Crossbard ends ( Ref 5). You will
find the Crossbar Center Rails (Ref 6) Inside.
2) Prop up the assemblies from Step 1 As shown. Insert x4 M6*10 machine screws (Ref 21)
through the holes of each Crossbar End (Ref 5) going into the Leg (Ref 1) and tighten the
screws. Then connect the other Leg (Ref 2) with the other Crossbar End (Ref 5) in the same way.
3) Attach the Side Brackets (Ref 8) to the assemblies from Step 2, as shown. Insert two M6*10
Machine Scerws (Ref 21) through the two holes of the Side Bracket (Ref 8) going into the
Crossbar End/Leg Assembly.
Repeat Step 3 with the other assemblies.
4) Slide the two Crossbar Center Rails (Ref 6) into the two Crossbar Ends (Ref 5)
5) Put the Rotating Bar (Ref 7) into the assemblies from step 4.
User Manual
