pa
ge 3
pa
ge 2
Safety
Instructions
Below are general safety precautions and warnings That should
be understood prior to setting up or operating your equipment.
Read and fully understand all instructions and warnings prior to
using this unit. Your safety is most important! Failure to comply
with procedures may result in serious injury or property damage.
Remember: Your personal safety is your responsibility.
W a r n i n g !
· Never operate or service your sealer until you have read
this manual completely and understand it fully.
· Only plug the sealer into a standard 110 Volt, 60Hz wall
outlet or surge protector.
· Do not use the sealer if the power cord, plug or any other
parts are damaged. Do not allow the power cord to drape
into your work area. Check that all parts are operating
properly and perform the intended functions. Replace any
worn parts before starting operation. Check for all other
conditions that may affect the operation of your sealer.
· Always disconnect sealer from power source before
servicing, changing accessories or cleaning the unit.
· To provide protection against the risk of electrical shock,
the power connection must be properly grounded at all
times.
· Do not leave the sealer unattended when in use. Disconnect
the sealer from the power source before leaving the work
area.
· Do not use the machine for any other purpose other than to
seal thermoplastic materials. Doing so may result in
damage to the machine and injury to the operator.
· Never touch the heating elements with hand while the
sealer is plugged into a power source, in operation or just
finished operation. Touching heated areas may cause fire
and/or severe burns.
· The sealer is not water resistant or water proof. Spraying
down the machine will damage machine or cause electrical
shock. Do not submerge the sealer into water or liquid.
· Do not operate sealer in a corrosive or humid environment.
· Always keep the machine clean and in good working
condition. Follow any maintenance procedures outlined in
this manual. Make sure unit is disconnected from power
source before cleaning.
· NEVER use any accessories or parts from other
manufacturers. Machine should not be altered or modified
using parts that are not genuine authorized parts. Doing so
will VOID YOUR WARRANTY
