STATUS
QUEUE REVIEW
FAULTS
KEYPAD
CONTROLS
DISABLEMENTS
FIRE
FAULT
PRE-ALARM
TEST
DISABLED
SYSTEM ON
ALARM FAULT
SUPPLY FAULT
SYSTEM FAULT
DELAYS
ACTIVE
SELECTED
DETECTORS
SOUNDERS
DISABLE
AUXILIARY
RELAYS
SOUNDERS
ACTIVATE/ SILENCE
SYSTEM RESET
LAMP TEST
BUZZER
SILENCE
DISABLED
TEST
FAULT
FIRE
ZONES
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
OPERATION
STATUS
FIRE:
If the LED is RED it indicates that there is a fire situation.
FAULT:
If the LED is AMBER it indicates a fault situation. Additional information will be shown on the LCD display and, if applicable, on
the LEDs in the FAULTS section of the main panel (i.e. 7, 8, 9, 10).
PRE-ALARM:
If the LED is AMBER it indicates that a detector is in PRE-ALARM.
TEST:
If the LED is AMBER it indicates that the panel is in a test mode.
DISABLED:
If the LED is AMBER it indicates that at least one disablement exists.
SYSTEM ON:
If the LED is GREEN it means that the panel is in ACTIVE mode. If the LED is flashing GREEN then the panel is in
INSTALLATION mode.
FAULTS
ALARM FAULT:
If the LED is AMBER it indicates that there is a problem with a loop sounder or conventional sounder circuit. This could
be an open or short circuit.
SUPPLY FAULT:
If the LED is AMBER it indicates that there is a Primary Supply (Electrical mains) Fault, a Battery Fault or that there is an
Earth Fault.
SYSTEM FAULT:
If the LED is AMBER it indicates that there is 5 Volt fault or a processor/program failure.
KEYPAD
KEYPAD:
Used to enter Authorized User code when available and gain access to all the functions associated with the key-switch
presses. This only applies to Juno Net En54 and Junior V4 panels. Installer Code can also be entered and it will provide access to all the
programming functions when this unit is networked to a Junior V4 panel but when unit is linked to Juno Net panel then only partial
control over certain programming functions will be available.
Manufacturers of Fire Detection Equipment
INSTALLATION MANUAL 1.0 - 12/2015
JUNIOR MINI-REP
