Glion SNAPnGO 315, Руководство пользователя

Страница: 24 / 37

23
09/20/18
The LCD Display is made up of 2 major components: 1. LCD screen 2 Control Buttons.
The Control Buttons has 3 buttons, Up Arrow or Gear Up (UP), Switch On/Off (SW) and Down
Arrow or Gear Down (DOWN).
The SETTING mode has 3 different tiers: Normal Setting, P value and C value. Below is a
complete instruction of settings for each mode. (Modifying top speed is in Normal Setting and
modifying gear 1/reverse gear torque is in C value setting.) Remember: short press of SW will
toggle between values, Up or Down will change values, long press of SW will get out of the
mode and long press Up and Down at the same time will change mode. If there is no
operation within 1 minute of getting into SETTING mode, the LCD will automatically leaving
SETTING mode and resume OPERATING mode.
Increase the top speed
1. Press SW to turn on the scooter
2. Within 5 seconds, press and hold Up and Down at the same time for 2 seconds. This will
allow user to get into the NORMAL SETTING mode. The speed column on Display will
be flashing. The default value is 10kmh. This is the top speed of Gear 3. By increasing
top speed of Gear 3, you would also increase the top speed of Gear 2 and Gear 1 as
lower gears speed are proportionate to top gear speed
3. Short press Up or Down to modify the speed. The highest speed SNAPnGO motor can go
is 17 kmh. So increasing the number above 17 would only provide a speed of 17 kmh at
maximum.
4. After modifying the top speed, you can either press and HOLD the SW to get out of
SETTING mode and back into OPERATING mode or you can short press the SW to toggle
to the next setting – motor wheel size.
Motor wheel size is set at 8 inch. This will NEVER change for SNAPnGO. Short press SW
to toggle to km Vs mile settings. This setting will see speed and distance value flashing.
The factory default is miles. Use Up or Down arrow to change it. Switching to KM will also
have the temperature measurements set to Centigrade from Fahrenheit.