PART TWO - INSTALLATION
SECTION 1 - UNPACKING
Rev. 1-398
Model 677F Remote-mount Analog Flowmeter/Transmitter
7
P A R T T W O - I N S T A L L A T I O N
S
ECTION
1
After unpacking, it is recommended to save the shipping
carton and packing materials if the instrument must be
stored or re-shipped. Inspect the equipment and packing
materials for signs of shipping damage. If there is any evi-
dence of damage, notify the transit carrier immediately.
S
ECTION
2
2.1 Location
2.2 Mounting
1. Locate the flowmeter within 2000 ft. (609 m) of where the
GLI impeller flow sensor is to be installed.
2. Mount the flowmeter in a location that is:
➥
Clean and dry where there is little or no vibration.
➥
Protected from corrosive fluids.
➥
Within ambient temperature limits (14 to 122
°
F;
-10 to +50
°
C).
CAUTION: MOUNTING THE FLOWMETER IN
DIRECT SUNLIGHT MAY INCREASE THE
AMBIENT TEMPERATURE ABOVE THE MAXIMUM
LIMIT.
Figure 2-1 illustrates the various ways to mount the flow-
meter using the supplied hardware and optional vertical
pipe mount hardware. Determine the mounting method and
attach the hardware as shown in the respective illustration.
Refer to Figure 2-2 for flowmeter installation dimension de-
tails.
UNPACKING
MECHANICAL REQUIREMENTS
