Page
12
of
30
11.
Input 2 Connectors
These 3 connectors are the audio input circuits from the turntable. Two of the
connectors are the left/ right audio circuits and these are standard RCA
(sometimes called phono) connectors.
The third connector is a 4mm screw terminal used for an audio ground circuit.
If the attached turntable has an equivalent ground/ earth connector then the
two should be connected.
12.
IEC Mains
The standard IEC mains plug accepts external AC voltages of 100 -240 VAC
+/- 10%.
There is an internal fuse and maximum current consumption is 10 Watts.
13.
USB Connector
This Mini USB connector is used for attaching the Athens 2 to a PC for
updating its firmware.
…..see updating firmware for further details.
14.
SFP Ethernet Slots
These 2 SFP Ethernet slots can accept most standard SFP (GBIC) modules.
Only one port is required to be connected to your network to correctly pass
Dante®/ AES67 network audio, however both the primary and secondary
ports can be used if a redundant network topology is in use.
Both ports are gigabit Ethernet and the LEDs flash to indicate data is being
correctly communicated with a switch.
15.
Input 1 Connectors
These 3 connectors are the audio input circuits from the turntable. Two of the
connectors are the left/ right audio circuits and these are standard RCA
(sometimes called phono) connectors.
The third connector is a 4mm screw terminal used for an audio ground circuit.
If the attached turntable has an equivalent ground/ earth connector then the
two should be connected.
