Page
14
of
29
In the third setup mode, the global channel colour can be set for each of the
four Dante inputs.
When the selection rectangle is hovering over the channel number; turning
the encoder will cycle through each channel.
When you wish to change the colour of the highlighted channel; simply long
press the encoder button and the rectangle will now highlight the colour name.
Now, turning the encoder will change which colour is selected.
When you have chosen the colour you want to select, long press the encoder
so that the selection rectangle returns to highlighting the channel number.
4. LS On/off
Turning the encoder adjusts the LS ring mute. If
‘Off’ is chosen, then the
loudspeaker is permanently muted regardless of the volume setting.
Make sure to long press the encoder when you have chosen your setting. The
display will show
‘Saved!’.
5. Brightness
Turning the encoder adjusts the light house RGB LED brightness. Low and
high allow different brightness for using the device in differently lit
environments.
Make sure to long press the encoder when you have chosen your setting. The
display will show ‘Saved!’.
To leave setup mode, simply push the encoder switch again to return to normal
usage.
The device will exit setup mode automatically after a few minutes if the device is not
interacted with.
