Page
17
of
29
Running Dante Controller
At the time of writing this manual the Dante
®
Controller looks as per the screenshot
below:
The AoIP22 will have been named at the factory during test to allow them to be
identified by the Dante
®
controller.
The format used for the factory name is:
‘AOIP22-sn-105-903ef5’
Where ‘AOIP22-sn-105 refers to the Glensound product and its serial number and
‘903ef5’ refers to its MAC address.
Dante Controller TIP
If you have never run Dante
®
controller before then make sure that on the bottom left
of the Dante controllers’ screen ‘P’ or ‘S’ is next to a green square as this indicates
that it is connected to a network. By clicking ‘P’ or ‘S’ a pop up box opens to allow
you to set what network interface the controller is using.