Glendo 004-895, Руководство по эксплуатации и обслуживанию

Страница: 9 / 24

77
MOUNT & CONNECT AIR FILTER
Mount air fi lter in a location where the air
fi lter may be drained daily (see FIG. 2.A).
Refer to FIG. 2 for instructions on
mounting the air fi lter to side of system.
Power off engraving system and air
supply. Insert appropriate hose (see
FIG. 2.3) into the fi tting until the hose
stops and is secure. Power on engraving
system and air supply to check for leaks
and improper connections; air should
not escape through any hose or fi tting.
If air leaks, power off system and air
supply. Locate leaks and correct any
improper connections. To disconnect
from a push‑to‑connect fi tting, press in
on the orange ring while gently pulling
out the hose.
CONNECT FOOT THROTTLE
Place foot throttle on the fl oor in a
convenient position. Extend throttle
hose to back of system (FIG. 3.D) to
insert into fi tting marked “THROTTLE
CONNECTION”. The hose should not
be pinched or kinked.
NOTE: The foot
throttle varies handpiece power by
controlling the amount of air that fl ows
from the handpiece. While the throttle
is depressed, it is normal for air to be
released. The user may hear the air
being released at times during operation.
CONNECT HANDPIECE(S)
Only one handpiece can be connected
and in operation at any time. Each
Standard Handpiece uses a single
push‑to‑connect fi tting (FIG. 3.A).
CONNECT ELECTRICAL POWER
DO NOT OPERATE
ENGRAVING SYSTEM
WITHOUT AN ACTIVE AIR SUPPLY
CONNECTED.
Insert the converter cord
into receptacle on engraving system
(FIG. 3.D and E). Connect the electrical
power cord into the 24-volt power
converter. Connect the 3-prong power
cord into a properly grounded power
outlet, using adapters as needed.
See pages 2-3 for details.
SETUP & CONNECTIONS