Glenayre Document Number: 9110.00148
RL-903 Rece
Issue
1, Rev. C:
12/10/96
REMOVAL AND REINSTALLATI
4.
Use nutdriver to remove nuts holding pc board to shock-mounting pegs. Hold bott
of mounting screws with screwdriver from bottom, if necessary.
5.
Lift board up and toward rear.
6.
Record positions of jumpers and programming switch if new board is to be install
7.
Replace shield and fasten with hardware, as appropriate.
Note
Be certain that no loose hardware, such as springs, is lost while the VCO
is out of its mounting.
9.5
RF Board Assembly
RF Board Assembly Removal
1.
Mark and remove power and signal connectors. Note polarity of connectors.
2.
Remove rear panel or BNC feedthrough to allow pc board clearance.
3.
Remove screws which hold pc board to chassis.
4.
Remove pc board by carefully lifting up.
Note
Be certain that the new RF board is tuned to the correct range if you are
replacing the front end assembly.
Print Date: 12/05/96
Copyright © 1996 Glenayre
Page: 9-3