Glen Dimplex Blaze B700, Руководство по эксплуатации

Страница: 10 / 16

8
3. REMOVING THE DOOR
To remove the door:
1. Open the door all the way.
2. Lift the door up and over the top end of the
vertical hinge rod.
3. Lower the door and slide off the bottom end
of the hinge rod.
4. ADJUSTING THE DOOR HINGE
Over time the screws securing the door hinge
plate to the heater may loosen resulting in the
door dropping, i.e. visually appears on slight
angle and no longer perfectly horizontal. This can
result in poor latch feel, a loose door seal and
unnecessary amounts of oxygen entering the
firebox and wood burning too quickly.
To fix this and reposition the door:
1. With the supplied 5mm hex key, loosen the
three screws on the hinge plate.
2. With the door 90% closed, slowly lift the
bottom right corner of the door until the
door is horizontal.
3. Keeping the door in that position relative to
the hinge, open it and tighten the screws
until firm.
4. Close the door to 90% again and make any
final adjustments up or down by tapping the
door on the right hand side until it appears
parallel relative to the top and bottom
surfaces of the heater.
5. Open door again and tighten screws fully.