Glen Dimplex Blaze B700, Руководство по эксплуатации

Страница: 12 / 16

10
7. FITTING NEW DOOR GLASS
This task may be easier with the door removed
from the heater and laid flat on a work-bench.
To replace the door glass:
1. Remove the six M8 button head screws and
twelve washers securing the glass retainer to
the door with the supplied 5mm hex key.
2. Gently lift the glass retainer up and out,
taking careful note that the glass may still
be held in the retainer and could fall out.
GLASS RETAINER
GLASS
3. Flip the retainer over, remove the old glass.
4. The new door glass panel should have been
supplied with a length of adhesive glass
seal. Peel back the backing on the tape,
and run it along the edges of the glass
panel, folding it equally over each side so
as to create a padded border around the
edge of the glass.
5. Fit the new glass into the glass retainer,
relocate the retainer so that all six threads
can be seen through the holes, before
fastening the six screws.
8. CHANGE FAN CONTROLLER
FREQUENCY
The frequency used by the fan remote control
can be changed if interferences are experienced
in the home.
Unplug the power lead before proceeding.
8.1. REMOTE CONTROL RECEIVER
The remote control receiver has four small
switches on the side, as seen in the photo below.
Change the switch setting to something different
than current setting. Remember this switch setting
as it will need to be replicated on the remote.
To access the remote control receiver:
Using the supplied 4mm hex key - remove the
receiver box that is held in place with two button
head screws in the rear of the wood box.
8.2. REMOTE CONTROL
Remove the battery cover and batteries. With
a small screwdriver or equivalent, change the
switch setting to be the same as that on the
remote control receiver.
Replace the batteries and cover, plug in the
power lead and test the fan with the different
frequency setting. If interferences are still
experienced, repeat the steps with another switch
setting configuration.