Glem P6140FV, Инструкция пользователя, Страница: 10 / 28

INSTALLATION INSTRUCTIONS
Important!
- The instructions are for a qualified installer.
- The appliance must be installed correctly, conforming to the laws in force.
- Remove the electrical power supply before intervening on the appliance.
- This appliance is not intended for use by person (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have
been given supervision or instruction concerning use of the appliance by a person
responsible for their safety.
- A steam cleaner is not to be used.
-
During use the appliance becomes hot.Care should be taken to avoid touching the heating
elements inside the oven.
- A steam cleaner is not to be used.
- If the appliance is placed on a base, measures have to be taken to prevent the appliance
slipping from the base.
Installation on the top (furniture plane)
The cooking hob can be installed on fittings as long as they are heat-resistant (minimum temperature 90°C)
The size of the hole to be drilled into the furniture plane and the minimum distance between the back, side and
overhead upper walls are shown in figures 43, 44, 45, 46, 47, 48 and 49.
Note that:
)
When the hob is installed without the oven in pair a separation panel is obligatory between the hob base
and the furniture underneath at a distance of at least 10 mm.
)
When the hob/oven are a pair, interpose a divider at a minimum distance of 15mm and following the oven
supplier’s instructions maintaining aeration as specified in fig.54.
In any case, electrical connection of the
two apparati must be carried out separately, both for electrical reasons and to facilitate extraction.
We recommend the use of an oven equipped with forced internal cooling.
Fixing the hob
The hob is to be fixed to the furniture as follows:
)
Place the sealing gasket supplied along the outside edge of the hole drilled in the fittings following the
scheme indicated in fig. 50 so that the ends of the strips are perfectly joined without overlapping.
)
Position the hob into the hole in the fittings making sure it is centered.
)
Attach the hob to the fittings with the supplied mounts as shown in fig. 51.
When the sealing gasket is correctly installed, it is an absolute guarantee against infiltration of liquids.
Place of installation and discharge of combustion products.
)
The appliance must be installed and operational in the best possible location and in any case
according to the laws in force.
The installer must refer to the laws in force concerning ventilation and evacuation of combustion
products.
We would remind you that the air necessary for combustion is 2m3/h for every kW of power (gas)
installed.
Place of installation
The place where the gas appliance is installed requires a natural air flow necessary for gas combustion (norms
UNI-CIG 7129 e 7131)
The air flow must come directly from one or more openings made on a free area of at least 100 cm
2
(A). If the
appliance does not have a safety valve, this opening should have a minimum area of at least 200 cm
2
(fig. 53).
The opening should be built so that it will not be blocked internally or externally and it is near to the floor,
preferably on the opposite side from the evacuation of combustion products.
If the required openings cannot be made, the necessary air can come from an adjacent room which is ventilated
as required as long as this room is not a bedroom, a dangerous area or under vacuum (UNI-CIG 7129).
Discharging combustion products
8