2
IMPORTANT:
Determine if your Tub/Shower Stall Enclosure ledge is
Level and Wall are plumb as shown in
Sketch 1A.
If they are out of Level/Plumb, by more than 1/4”,
STOP!
and call Customer Service. The Phone number is
1-888-683-1362
A Base filler and /or Wall Jamb Filler are recommended
for obtaining proper adjustment;
both are available through Customer Service.
If they are Level/Plumb, or out of Level/Plumb for less than
1/4” proseed with installation.
1
Sketch 1 A
Installation Instructions for GlassCrafters Epic By-Pass Shower Enclosure
IMPORTANT: Read all instructions carefully and become familiar with all parts before installation.
Cleaning:
Never use scouring powder, pads or sharp instruments on metal work or glass panels. We recommend
the use of a squeegee after each shower to eliminate water spots on the inside of the glass panels.
An occasional wiping down of the glass panels and anodized aluminum parts with a mild detergent,diluted in water,is
all that is needed to keep your Shower /Tub Enclosure looking brand new.
Unpacking:
Care should be taken unpacking your Shower Enclosure. Place the Glass Panels in an upright,
Safe location to avoid damage. Never place glass directly on hard surface.
A Box cutter should not be used to open box.
Please remove all staples from the box prior to unpacking metal and glass.
Sketch 2A
Inside
Sketch 2B
Wall Channel # 19
Set the Wall Channel #19 on the wall and mark holes for screw anchors (
Sketch 2A
). Use Level to make sure
that Channel is plumb. Remove the channel. Drill all marked holes and, clean the Tub
/
Shower Enclosure ledge and
the Wall Jamb areas thoroughly. Insert Wall Anchors #11 into the drilled holes and install Wall Channel using
Screws #12 as shown in
SKETCH 2B
. Do not apply Silicone Sealant to the back side of the Wall Channel Sealing
the Wall Channel will be completed in the final step.