10
STEP 7 -- Install the Door from the Inside of the Unit:
Two persons should be used to lift the Door onto the
Horizontal Rail. The bottom of the door goes in the Plastic
Insert in the Center Guide. Install the Anti-Lift Standoff
Assemblies in the pre-drilled holes in the door below the
Horizontal Rail. The Anti-Lift Standoff threaded knob
inserts from the inside. Be sure to use the gaskets
between the knobs and the glass as well as the plastic
bushing within the hole to protect the glass. Screw the
Anti-Lift Standoff Assemblies in place hand tight.
(Final installation with the set screw is completed in Step
#10 after the roller adjustment procedure.)
7b) Move the door to the closed position and then relocate
the Door Stop/Bumper to the proper location against the
roller when the clear vinyl bumper makes contact with the
wall.
7c) Move the door to the fully open position and relocate
and set the Door Stop/Bumper to prevent the door handle
from hitting the panel and/or to prevent the door glass
from hitting the wall.
DETAIL #7a
DETAIL #7
(As viewed from the outside)
DETAIL #7b
(Panel with fittings as viewed from the side)
Anti-Lift Standoff is installed on
the Door under the Horizontal Rail
to prevent unmounting of the door.
Do Not tighten in place until after
the roller adjustment in Step #10.)
Using the set screw at the bottom
fix the Door Stop/Bumper in
position
