Installation
6-Option 2
6-Option 3
Screw Installation
□
7
Installing the showerhead
□
Push the top side of the slide bar onto the
connector (
D
), place the bottom part of the slide bar
to the seat (
F1
) and rotate clockwise to secure the
bottom side tight to the seat (
F1
).
Tighten the set screws(DD) to lock the slide bar to
the connector as below.
Tape Installation
8
Insert the rubber sealing washer (
K1
) into the end
of the showerhead connector and install the
showerhead (
K
) by twisting clockwise onto the
pipe (
J
).
8
Installing the hose
□
Insert one of the rubber sealing washers into the
end of the hose connector (
M
) and hand tighten to
the hand shower (
L
). Hand tighten only.
Insert sealing washer into the other end of hose
connector (
M
) and hand tighten to the outlet
connecter on the slide bar (
F
) as shown below.
K
J
□
L
M
M
F
DD
CC
D
F1
NOTE:
You may need to slightly loosen the set screws before
inserting the connector to avoid damaging the O-rings.
□
K1
□
□
Push the top side of the slide bar onto the connector
(
D
), place the bottom part of the slide bar to the seat
(
F1
) and rotate clockwise the bottom part of the slide
part to secure the bottom part tight to the seat (
F1
).
Tighten the set screws (DD) to lock the slide bar to
the connector as below.
DD
CC
D
F1
NOTE:
You may need to slightly loosen the set screws before
inserting the connector to avoid damaging the O-rings.
