11
Making the water supply connections
Thread the nut (1) on the supply line onto the outlet of the
water supply valve (2) and tighten with a wrench. Do not
overtighten.
NOTE: The hot side inlet tube is indicated by a label. Avoid
twisting wires together or placing the wires close to each
other and damaging.
1
2
Flushing and checking for
leaks
Pull the hose assembly out of the spout and remove
the spray head by unscrewing it from the hose in a
counterclockwise direction. Be sure to hold the end of
the hose down into the sink and turn the faucet to
the warm position where it mixes hot and cold water.
Flush the water lines for one minute. This flushes away
any debris that could cause damage to internal parts.
Check for leaks.
Re-tighten any connections if necessary, but do not
overtighten. Reinstall the spray head by hand tightening
it back onto the spray hose in a clockwise direction.
IMPORTANT: After installation is completed, turn on the
hot and cold water supplies. Check for leaks. Do not lose
the gasket (1) in the hose.
12
Attaching the quick connector
to the receiving block
9
10
9
18
Weight
here
Weight
here
20
20
19
19
Installing the weight
Install the weight clip (20) at the point of the hose marking
"weight here”.
Insert the weight (19) onto the clip (20) by sliding it down
onto the clip (20).
Push the quick connector (18) firmly upward and attach it
to the receiving block (9). Pull down moderately to ensure
the connection has been made.
HOMEDEPOT.COM/GLACIERBAY
Undermount Installation (continued)
9
