6
Installation (continued)
Installing the horizontal rod,
stopper, and strap
5
Preparing the pop-up assembly
□
Remove the stopper (J) and the flange (K).
□
Screw the nut (M) all the way down, and push the
gasket (L) down.
7
□
Remove the pivot nut (O).
□
Install the horizontal rod (P) and the stopper (J),
as shown (1).
□
Hand tighten the pivot nut (O).
□
Attach the horizontal rod (P) to the strap (S)
using the clip (Q).
6
Installing the pop-up body and
pop-up flange
□
Apply silicone to the underside of the flange (K).
□
Insert the pop-up body (N) into the sink. Screw
the flange (K) onto the pop-up body (N). The pivot
hole (1) must face the back of the sink.
□
Use the groove joint pliers to tighten the nut (M),
but do not over tighten. Do not turn the pop-up
body (N) while tightening the nut (M) or the
sealant may not seal properly. Clean away
any excess putty.
K
J
M
L
N
1
M
SILICONE
K
O
P
J
1
S
Q