7
Care and Cleaning
□
To clean, wipe down with a damp cloth and dry with a towel.
□
Do not use abrasive cleaners, steel wool, or harsh chemicals when cleaning this faucet, or the warranty will
be voided.
Troubleshooting
Problem
Possible Cause
Solution
There are leaks from the
handle.
The bonnet nut has come loose and/or the
washer is dirty or damaged.
□
Tighten the bonnet nut.
□
Clean or replace the washer.
The water will not shut off
completely.
The cartridge is dirty or broken.
□
Remove the handle to check
the cartridge.
□
Clean or replace.
NOTE:
Refer to the service parts section in this manual for
a detailed drawing showing the location of the parts listed
below.
HOMEDEPOT.COM
Please contact 1-855-HD-GLACIER for further assistance.
Operation
1
Flushing and checking for leaks
□
Turn on the water supply and allow both hot
and cold water to run for at least one minute
each. Press the pin (1) to the bottom position,
and flush water lines for one minute. This
flushes away any debris that could cause
damage to internal parts. Check for leaks.
□
After flushing, turn the handle all the way
off to shut off the water and reinstall the
aerator. The pin should now be in its normal
position. Re-tighten any connections if
necessary, but do not overtighten.
IMPORTANT:
After installation is complete, remove the
aerator from the spout (A) with the plastic wrench (D) to
flush the water lines.
D
A
1
