3. On the remote control for Media Center PC, press and release the TV Power, VOL+, VOL-, Numeric keypads (0
through 9), CH+, CH-, or Mute button, depending on which command you want it to learn.
The remote control for Media Center PC Green LED blinks once to confirm the selection.
In the learning setup mode, Red LED blinks quickly four times when two conditions occurring: (Try again, repeat
steps 1 to 3)
z
If you press other buttons than TV Power, VOL+, VOL-, Numeric keypads (0 through 9), CH+, CH-, and
Mute buttons
z
If you do not press any button in 5 seconds.
4. On the remote control that is teaching the command, press and hold the button that you want the corresponding
button on the remote control for Media Center PC to learn
Before you release to hold this button, the remote control for Media Center PC Green LED blinks twice to confirm
the selection.
If the remote did not learn the command, the Red LED blinks quickly four times. To try again, repeat steps 1 through
4.
5. Repeat steps 1 through 4 for the other buttons that can learn commands.
2.5 iMON Module Quick Guide (A381 iMON version)
1. S/W Installation
Insert “iMON CD” to your CD-ROM, and install iMON software and Multi-Median according to the auto running
S/W installation process.
2. H/W (IR Receiver) Installation
The additional feature of internal type iMON IR receiver is that you can power on your PC system using the
power button of the remote controller. After turn off your PC system, open the PC case and connect the cables
to its proper pin refer to the following picture. Internal IR receiver is connected to mainboard with two cables, PC
case with one cable, Power Supply with another cable. You should be careful to connect these four cables refer
to your mainboard manual. If you connect the iMON IR Receiver before the S/W installation, then assign the
H/W driver according to the ‘Found New H/W Wizard’. Select CD ROM drive for searching H/W driver which has
the installation CD inside.
