English
CCD-0006001 Rev: 05-16-22
- 15 -
Replacing an Oven Light
1. Disconnect the oven from the power supply by means of the switch
used to connect the appliance to the electrical mains, or unplug the
appliance if the plug is accessible.
2. Remove the glass cover of the lamp-holder. (Fig. 27)
Fig. 27
3. Remove the lamp and replace with a lamp resistant to high
temperatures (300
o
C / 572
o
F) with the following characteristics:
- Voltage: 12V
- Wattage: 10W
- Type: G4
- Lamp Type: Halogen
4. Replace the glass cover.
5. Reconnect the power to the oven.
To reorder the Girard oven light bulb replacement, please contact your
service center for assistance.
Replacing the Control Knob LED
1. Disconnect the oven from the power supply by means of the switch
used to connect the appliance to the electrical mains, or unplug the
appliance if the plug is accessible.
2. Grasp and pull on the control knob with the broken LED light. (Fig.
28)
Fig. 28
3. Remove the two screws holding the LED light using a Phillips
screwdriver. (Fig. 29)
Fig. 29
4. Remove the LED assembly and disconnect the wire from the base of
the LED assembly. (Fig. 30)
Fig. 30
5. Plug the wire harness connector into the new LED assembly.
6. Reattach the LED assembly to the console with the 2 screws
removed in step 3. Ensure the wires are not pinched during this
process.
7. Reattach the control knob by aligning the stem of the control into
the opening in the control knob housing and pushing it back into
position.
