Gira Cube 120, Руководство по эксплуатации

Страница: 18 / 40

18
Wall installation

Fasten the mounting plate to the wall
(Fig. 1).

Pierce the rubber grommet in the angled
mounting bracket and insert the lines.
Attach the angled mounting bracket to the
mounting plate (Fig. 2) and press it closed
(Fig. 3).

Attach the sensor unit to the angled
mounting bracket (Fig. 4) and connect it
according to the wiring diagram (Fig. 15 to
17).

Push the sensor unit up into the angled
mounting bracket and snap it in place
(Fig. 5).

Slide the cover over the sensor unit and
place the cover on the angled mounting
bracket (Fig. 6).
Ceiling mounting

Fasten the mounting plate to the ceiling
(Fig. 8).

Pierce the rubber grommet in the angled
mounting bracket and insert the lines.
Attach the angled mounting bracket to the
mounting plate (Fig. 2) and press it closed
(Fig. 3).

Attach the sensor unit to the angled
mounting bracket (Fig. 11) and connect it
according to the wiring diagram (Fig. 15 to
17).

Push the sensor unit up into the angled
mounting bracket and snap it in place
(Fig. 12).

Break out the drainage opening in the cov-
er (Fig. 13).

Slide the cover over the sensor unit and
place the cover on the rear of the angled
mounting bracket (Fig. 13).
LED function
Restrict detection field
The detection field can be restricted using the
covering panel, e.g. to suppress sources of
interference.

Slide the cover down (Fig. 21).

Loosen the lens screws on the sensor unit
(Fig. 22).

Push the lens in the direction of the angled
mounting bracket (Fig. 23).

Remove the lens (Fig. 24).

If necessary, cut out the covering panel
with scissors along the marked lines
(Fig. 25).

Place the covering panel in the lens and
mount the lens again in reverse order.
I
Note on parallel mounting
(Fig. 17)
- Do not exceed the maximum con-
nected load of a motion detector.
- Connect all motion detectors to
the same phase.
- Up to 10 motion detectors can be
connected in parallel.
- The cable length between two
motion detectors must not exceed
50 m.
Normal operation LED off
Test operation LED lights up during
movement
Continuously ON/
OFF LED lights up
Teach-in / day mode The LED flashes five
times. Teach-in or
day mode is acti-
vated.
Remote control LED flashes