Wireless remote control, 2-gang, Wireless remote control, 4-gang
Status LED (1) flashes red. The hand-held transmitter is in programming mode for approx.
1 minute.
￭
Press the right or left button of the required channel or the scene button briefly
The status LED lights up for approx. 5 seconds, and the channel buttons or scene button
are connected to the actuator. The hand-held transmitter and actuator exit the program-
ming mode automatically.
The All Off button is connected to the actuator automatically as soon as the first connec-
tion to a radio transmitter takes place. Scene buttons must be connected separately.
If the status LED of the radio transmitter flashes 3 times at 1-second intervals for approx.
5 seconds, then the programming operation was not successful. The actuator is outside
radio range, not in programming mode or there are radio faults.
If the status LED of the actuator flashes 3 times at 1-second intervals for approx.
5 seconds, then the programming operation was not successful. All the memory locations
in the actuator or radio transmitter are occupied.
Press the Prog button once again for longer than 4 seconds to terminate the programming
mode earlier.
Disconnecting connection to an actuator
￭
Carry out the same steps as when connecting (see the chapter Connecting to radio actu-
ator).
The status LED of the actuator flashes quickly for 5 seconds. The actuator is disconnec-
ted from the radio transmitter. The actuator and radio transmitter exit the programming
mode automatically.
If there several connections or scene buttons for an actuator, all the connections must be
disconnected individually.
The All Off button of a radio transmitter is disconnected automatically as soon as the last
connection to the actuator is disconnected. Manual disconnection is not possible.
Resetting the channel or scene button
All the connections of the channel buttons or the scene button to actuators are disconnected
and parameters are reset to default setting.
The connections in the actuators are preserved and must be deleted separately.
￭
Press the Prog button for longer than 20 seconds.
The status LED (1) flashes red after 4 seconds. The status LED flashes faster after
20 seconds.
￭
Release the Prog button and press briefly a channel button of the appropriate channel or
the scene button once again within 10 seconds.
The status LED flashes more slowly for approx. 5 seconds.
The channel buttons or the scene button has been reset. The setting as channel buttons
or scene button is retained.
Resetting the hand-held transmitter to the default setting
All connections to actuators are disconnected and parameters are reset to default setting.
The connections in the actuators are preserved and must be deleted separately.
￭
Press the Prog button for longer than 20 seconds.
The status LED (1) flashes red after 4 seconds. The status LED flashes faster after
20 seconds.
￭
Release Prog button and press briefly once again within 10 seconds.
The status LED flashes more slowly for approx. 5 seconds.
The hand-held transmitter is reset to default setting. All the buttons are set as channel
buttons.
5 / 8
32582432
10867219
18.12.2019
