GIRA
Info
Radio-Control Presence Detector
Installation Instructions
Radio-Control Presence Detector
7/07
Page 3 of 15
Batteries
The radio-control presence detector operates on 4 al-
kaline micro batteries (LR 03) (not included in the
scope of supply). Batteries of the carbon-zinc type
(R 03) must not be used.
Inserting / replacing the batteries
1. Detach the presence detector from the baseplate
by turning the device approx. 45° clockwise on the
baseplate (fig. 2.d).
2. Replace the old batteries located at the back of the
housing. Wait ca. 2 minutes (capacitor discharge
time) before inserting the new ones paying atten-
tion to correct polarity (fig. 2.e).
3. Refit the presence detector on the baseplate by
turning the device approx. 45° counter-clockwise
until it is heard to engage
4. After insertion of the batteries, the device starts
transmitting programming telegrams for ca. 30
seconds.
To avoid undesired programming make sure that
none of the actuators is in the programming mode
during this time.
2.d)
2.e)
Programming a detector into a radio-control
receiver
For light control applications, the presence detector
must be programmed into only
one
radio-control re-
ceiver. The programming information is stored in the
radio-control receiver only.
During programming of a radio-control presence de-
tector, the sensitivity of the radio-control receivers is
reduced to approx. 5 m. The distance between the re-
ceiver and the radiocontrol presence detector should
therefore be not less than 0.5 m and not more than 5
m.
Programming procedure
1. When programming the first presence detector into
the radiocontrol receiver make sure the brightness
control (fig. 2.f
i
) does not point to the „Moon“
symbol. A presence detector with this setting will
be identified as a slave unit and can therefore not
be programmed as first unit into a radio-control re-
ceiver.
For programming of a presence detector system
(master/slave) please read also section 9.
2. Remove the battery for approx. 2 minutes from the
presence detector (capacitor discharge time).
3. Switch the radio-control receiver into the program-
ming mode (see „Radio-control receiver“ operating
instructions).
4. Put the battery back in place. The presence detec-
tor now starts transmitting special programming in-
formation telegrams for approx. 30 seconds. The
receiver confirms the programming cycle (see „Ra-
dio-control receiver“ operating instructions).
5. Switch the radio-control receiver back to the opera-
ting mode (see „Radio-control receiver“ operating
instructions).
2.f)
Safety and disposal instructions
Attention: Keep batteries away from children.
Remove used batteries immediately and discard
without polluting the environment.
Replace battery by identical or equivalent types
only.
