Gina 2000-64K, Руководство пользователя

Страница: 3 / 17

GINA User’s Manual
Controls and Indicators
Front Panel
As shown in Figure 6-2, operating indicators, a voice handset jack, and
the command data port are located on the front panel and consists of:
1. PWR LED (Light Emitting Diode). This LED is lit when
power is applied to the transceiver.
2. TX LED. Indicates that a signal is being transmitted by GINA.
3. RX LED. Indicates a receiving condition on GINA.
4. ST LED. When green, GINA is receiving good data. When
red, data has errors, GINA is receiving bad data, or the GINA
units are not synchronizing.
5. Voice Handset Jack. Standard RJ22 telephone jack for the
GINA handset.
6. RS-232 Command Control Data Port. Used for programming
during GINA setup. This port communicates at 9600 kbps
asynchronous only.
NOTE: GINA only operates with the handset supplied with the unit.
Do not attempt to use a standard telephone handset.
©1999 GRE America, Inc. All rights reserved. This material is the property of GRE America, Inc. Copying or re-producing this
material is strictly prohibited. All violators shall be prosecuted to the fullest extent of the law.
1/99
1-2
Figure 6-2. GINA Transceiver Front Panel
Voice Handset Jack
Status LED
Receive LED
Transmit LED
Power LED
GINA Setup Port
Power ON/OFF Switch