Gill Instruments 1086-G-045, Руководство пользователя

Страница: 50 / 91

Gill Instruments Ltd
Intrinsically Safe WindObserver Anemometer Page 50 Issue 10
Doc. No. 1360-PS-0001 May 2015
Change settings if required referring to the previous configuration details.
Type Q and press Enter to go back into measurement mode.
If powering down the instrument and repowering and no change has been made to the
baud rate (B command ) then open a new terminal program at the units original baud rate
setting (the default setting would be 9600 Bauds to view data).
10.5 Status (error) codes
The Status code is sent as part of each wind measurement message.
Code Status Condition
00 OK Sufficient samples in average period
A OK NMEA data Acceptable
01 Axis 1 failed Insufficient samples in average period on U axis
02 Axis 2 failed Insufficient samples in average period on V axis
04 Axis 1 and 2 failed Insufficient samples in average period on both axes
08 NVM error NVM checksum failed, data could be uncalibrated.
09 ROM error ROM checksum failed, data could be uncalibrated.
51
Measurement average
building. Data valid but warns that average period not reached
when averaging used.
V NMEA data Void Invalid data output