Gilian Gil Air Plus Скачать руководство пользователя страница 7

Страница: 7 / 9

IOM Sampling with the Gilian GilAir Plus Pump Procedure

4. Run tubing under the arm to collar/breathing zone area. Clip IOM on shirt.



Make sure IOM filter is open to the front (to allow proper air flow) and is

stationary.

Use additional clips on tubing to attach to the person’s shirt, allowing a little slack
on tubing as shown in photo 8.

6. Remove cap from the IOM.

Photo 8. IOM Filter Correctly Oriented on Wearer, with Cap Removed

7. Turn pump on by pressing the check mark/power button with the indicator on the

“Run” option.



The flow will gradually increase to 2000 cc/min. A flashing green light will

appear at the top of screen. This indicates that the pump is in fact in the
run mode.

Содержание Gil Air Plus

Страница 3: ...IOM Sampling with the Gilian GilAir Plus Pump Procedure 3 Photo 3 Tubing Configuration of the Calibrator Calibration adapter and Pump ...

Страница 4: ...ower button until the light inside turns on and the piston will drop Photo 4 Calibrator Powered On Piston Dropped 2 The measure option will be highlighted Select Enter 3 Use the right arrow to scroll over to CONT Continuous to run the calibrator continuously until manually stopped 4 Connect other end of tubing onto pump inlet ...

Страница 6: ...Once pump is calibrated disconnect it from calibration train 2 Attach tubing with APHC LAB IOM sampler to the pump inlet tubing will be approximately 20 inches in length for personnel sampling 3 Use clip on backside of pump to hook on person s belt behind the hip as indicated in photo 7 Photo 7 Gilian Pump Appropriately Attached to Belt ...

Страница 8: ...Pump 8 When done sampling press the check mark power button Use down arrow to scroll to Stop Press check mark power Stopping the run will end that sampling event Pausing the pump will pause the current sampling event and will resume once started again Photo 10 Pausing or Stopping the Gilian Pump ...