Gilbarco MDE-3664B, Руководство по запуску, обслуживанию и запасным частям, Страница: 74 / 131

MDE-3664B TRIND® Start-up, Service, and Parts Manual · June 2013 Page 6-1
Positioning Overhead Antennas Procedures for Factory Installed TRIND
6 – Procedures for Factory Installed TRIND
Positioning Overhead Antennas
TRIND overhead antennas are shipped mounted to the unit in the down position. Figure 6-1
shows the TRIND antenna hardware and final antenna positioning on the unit.
Figure 6-1: Positioning TRIND Antenna
Perform the following procedures to position each overhead antenna:
Note: If installing the Mobil Display Cabinet (Blue Hat), leave the antennas in the down
position until the display cabinet is installed. For display cabinet installation
instructions, refer to
“Dispenser Setup” on page 7-1 .
See Figure 6-1 and perform the following steps to position the overhead antenna into its final
position. Perform these steps for each side of the unit:
1
Loosen the bolts on the each side of the unit that secure the antenna boxes to the antenna
brackets using a 3/8-inch nut driver.
2 Slide the antenna forward and away from the fueling unit in the bracket slots.
3
Rotate the antenna to the upright position parallel to the ground.
Molded Tab
Bolt Slot
Wires
Bolt