15
SECTION 4 - INSTALLATION
4
MDE-5224F
DCM2 Assembly
The DCM2 Assembly Board (M14576A001) mounts in the same location as the M13124A001 AFP Board,
with the same cable connections. The M14576A001 DCM2 Board provides the same functionality as the
AFP, along with a high-speed data connection for the Applause Media System, Insite360™, and future EMV
applications. Similar to AFP, M14576A001 DCM2 Board can host two GSoM boards for Applause Media
System. On the rear side of the M14576A001 DCM2 Board, there is a mounting point for the SSoM for
Insite360 Encore.
Figure 5: Mounting DCM2 Assembly
P302A to
Side A Door
J3*
J4
*If J3 is installed, the high-speed data is over the two-wire and these connectors are disabled.
**With J3 In, the high-speed connection comes over the pump two-wire in case J4 is removed.
If J4 is also installed [Major Oil Company (MOC)], the pump and CRIND wiring functions are swapped so that the CRIND data wires are
connected at the location where the pump data wire was previously connected.
Out = Generic
In = MOC
P304B Convenient Ethernet
Field Wiring
Note: This is wired in parallel
with J304A, so use only
one.
P304A RJ-45 Field Wiring Point
(required for Applause Media
System)
RJ-45 for Dispenser Connections
24 V In
24 V Out
Two-wire to Pump
(required for
Applause Media
System)
24 V Out
Pump and
CRIND
Two-wire
Connections**
P302A to
Side B Door
GSoM A
GSoM B
RJ-45 Port
(required for
technician’s
laptop)
