Gigawave D-Cam Clip-On, Руководство оператора

Страница: 19 / 30

D-Cam Clip-On Operators Manual Issue 1 Page 19 of 19
UNUM-CCAM -0104
Make sure that all batteries to be used are fully charged and whenever possible, provide a
spare with the cable to connect it to the Receiver.
Check that the Receiver channel frequencies are compatible with those of the D-Cam Clip -
On Transmitter and set the channel selector switch to the channel number required. The
Receiver is labelled with channel number and frequency information. As a precaution, set
the manually selectable frequency of the Receiver to the working frequency then close and
refasten the selector switch window assembly.
The Receiver Head unit should be set with its channel selector switch set to SLAVE and
the manual frequency selection set to the channel frequency to be operated.
The Receiver Head and Control units may be operated at distances up to 600 metres
apart. Gigawave triax cable is supplied in standard lengths of 100 and 200 metres and will
plug together to create the lengths required. Check that the necessary lengths of triax
interconnecting cable are available and that the cable and cable connectors are in
serviceable condition.
Unless built to a specific customer requirement, the MVL Receive Control unit will be
equipped for two analogue audio channels or one AES3 output. Check that the audio to be
used by the Wireless Camera is set to the correct input levels.
Whenever practical, set up the system and trial it before leaving for site to ensure
that all components of the system are working. Checking at base, where
adjustments and corrective actions can be made, will pay off when setting up at
site.