6
2.3 Front
Panel
2.3.1 10/100Mbps
TP
Ports
Each 10/100Mbps TP port provides an Auto-Negotiation function that senses for
the attached device's maximum operating speed and automatically sets the
Switch to operate at that speed. Users only need to connect a network device
into any TP port. Auto-MDIX is also supported on all TP ports which allows
uplinking to another Switch free of cross-over or straight cable selection hassle.
2.3.2 Cabling
10Mbps
-When transmitting at 10Mbps Category 3, 4 or 5 TP cabling with
RJ-45 sockets can be used.
100Mbps
-To transmit at 100Mbps requires Category 5 TP cabling.
Port Type
Cable Type
Connector
10BASE-T
Category 3, 4 or 5 TP
RJ-45
100BASE-TX Cat.5
TP
RJ-45
Note:
Category 5 UTP cable is recommended whenever installing new cabling.
2.3.3 Status
LEDs
The Switches come with a complete range of LEDs. The table below lists each
LEDs name, color and a brief description of its function.
Name Color
Function
Pwr
Green Lit: Power "On"
LINK/ACT Green Lit: When the port has a valid physical connection with another
device.
Blinks: When the port is sending or receiving data (Activity).
FD/COL
Amber Lit: When the port is set to Full-Duplex mode.
Blinks: When a collision is detected, when the port is in
Half-Duplex mode.
2.4 Rear
Panel
2.4.1 Power
Socket
The Power Socket is designed to be used with the power cord included in the
product package.
．
Attach the female end of the cord to the power connector on the back panel.
．
Attach the male end of the cord to a grounded power outlet.
