1. Introduction
Thank you for purchasing our 10/100 Fast Ethernet Adapter. Fast Ethernet Adapter
that provides the best possible performance. The RJ-45 port contains auto-negotiation
functions that allow it to intelligently mediate between full and half-duplex modes,
thereby facilitating the speed of migration between 10Base-T and 100Base-TX.
Furthermore, when used with a switching hub that supports full duplex, the speed is
effectively doubled to 20/200Mb. Lastly, on board LEDs and the diagnostic software
provided make it a simple task to monitor an entire network's activity.
Designed in the plug-and-play solution, this Fast Ethernet Adapter's installation is
hassle free, automatically configuring itself upon power-up to avoid conflicts. Its
comprehensive and intelligent auto-install software installs the correct driver for the
network operating system of your choices.
2. Features & Technical Specification
(1) Features
!
Complies with the IEEE802.3 CSMA/CD, 100Base-TX and 10Base-T standard.
!
Support 32-bit PCI Bus Master for high performance and low processor utilization.
!
Full duplex design to double the performance to 20Mbps/200Mbps.
!
Support Auto-negotiation function.
!
Auto-setups IRQ and I/O address.
!
Built-in FIFO buffers to eliminate external memory.
!
One STP connector for 100Mbps or 10Mbps network speed.
!
Supports early interrupt on transmit to increase performance.
!
Supports ODI driver for NetWare 3.x/4.x; NDIS driver for LAN Manager, Windows 95,
Windows 98, Windows NT; Packet Driver for TCP/IP software.
!
Provides diagnostic software and LEDs to indicate network status.
!
Supports smart remote Boot ROM (optional)
!
Supports APCI Wake on LAN (optional)
(2) Technical Specification
!
Topology
: Star
!
Connector
: RJ-45
!
Standard
: IEEE802.3 10Base-T; IEEE802.3 100Base-TX
!
Transmission Rate
: 10Mbps or 20Mbps; 100Mbps or 200Mbps
!
Hardware Required
: IBM compatible PC with available PCI slot
!
RQ Line
: Assgned by system
!
I/O Address
: Assigned by system
!
Drivers
: ODI driver for NetWare 3.x/4.x NDIS driver for LAN Manager,
Windows 95, Windows 98, Windows NT, Packet Driver for
TCP/IP software.
!
Temperature
: 0°C to 55°C (Operating)
!
Humidity
: 10% to 90% (Non-condensing)
!
Certification
: FCC Class B, CE Mark
!
Power consumption
: 1.8W (Max.)
