Hardware Troubleshooting
This chapter contains information to help you solve problems.
If the 16/24-port Ethernet Switching is not functioning properly,
make sure the 16/24-port Ethernet Switching was set up
according to instruction in this manual.
The Link LED is not lit
Solution:
a. Make sure the switch configuration is consistent with the
connecting device
b. Check the cable connections.
Performance is bad
Solution:
a. Check the full duplex status of the Ethernet Switching. If the
Ethernet Switching is set to full duplex and the partner is set to
half duplex, then the performance will be poor.
Some stations can not talk to other stations located on the
other port
Solution:
a. The address table may contain older information than of the
address table of that node. Please power down to refresh the
address information.
