Hardware Installation
Place the 16/24-Ethernet Switching on a smooth surface.
Connect the output of power cord to the AC-inlet of
16/24-port Ethernet Switch.
Connect hub or PC to one port of the 16/24-port Ethernet
Switching using Category 3/4/5 UTP/STP cabling.
Connect another hub or PC to the other port of 16/24-port
Ethernet Switching by following the same process as
described in Step 3.
Notice:
Cable distance for 16-port Ethernet Switching
The cable distance between 16/24-port Ethernet Switching
and hub/PC should not exceed 100 meter.
Make sure the wiring is correct
It can be used Category 3/4/5 cable in 10Mbps operation. To
reliably operate your network at 100Mbps, you must use an
Unshielded Twisted-Pair (UTP) Category 5 cable, or better
Data Grade cabling. While a Category 3 or 4 Cable may
initially seem to work it will soon cause data loss.
All kinds of hub /PC can connect to switching hub by using
straight- through wires. The hub provides one additional
RJ45 connector which is converted from port 16, labeled
“any Ports” for the connection is from hub or PC.
