Gigabyte GA-X79-UD5, Руководство пользователя

Страница: 92 / 116

Appendix - 92 -
Figure 3
B. Installing Windows XP (For the Marvell 88SE9172)
(Note)
Before installing Windows XP, connect a USB loppy disk drive to your computer irst because you need to in
-
stall the SATA RAID/AHCI driver from a loppy disk that contains the driver during the OS installation. Without
the driver, the hard drive(s) may not be recognized during the Windows setup process. First, copy the driver
from the motherboard driver disk to a loppy disk. Refer to the methods below.
Method A:
For RAID mode, copy all iles in the
•
\BootDrv\Marvell\RAID\Floppy32
folder to your loppy disk. To
install Windows 64-Bit, copy the iles in the
Floppy64 folder.
For AHCI mode, depending on whether you want to install the 32- or 64-bit version, copy the iles in the •
AHCI\Floppy32 or AHCI\Floppy64 folder.
Method B:
Steps:
Use an alternative system and insert the motherboard driver disk. 1:
From your optical drive folder, double click the 2: Menu.exe
ile in the
BootDrv folder. A Command Prompt
window will open similar to that in Figure 3.
Insert the blank formatted disk (if you're using a USB loppy disk drive, make sure it is designated as drive
3:
A). Select the controller driver by pressing the corresponding letter from the menu and press <Enter>. For
example, from the menu in Figure 3, select
7) Marvell RAID driver . (For AHCI drive(s), select Marvell
AHCI driver .)
Your system will then automatically copy the driver iles to the loppy disk. Press any key to exit when in
-
ished.
(Note) The X79 SATA RAID/AHCI driver does not support Windows XP 32-bit. To install Windows XP 64-
bit, search for the installation instructions on the
Support & Downloads\FAQ page on our website.