Gigabyte GA-F2A88X-D3HP, Руководство пользователя

Страница: 63 / 96

- 63 -
Coniguring a RAID Set
Rebuilding an Array:
Rebuilding is the process of restoring data to a hard drive from other drives in the array. Rebuilding applies
only to fault-tolerant arrays such as RAID 1, RAID 5, and RAID 10 arrays. To replace the old drive, make sure
to use a new drive of equal or greater capacity. The procedures below assume a new drive is added to replace
a failed drive to rebuild a RAID 1 array.
While in the operating system, make sure the Chipset and RAID drivers have been installed from the motherboard
driver disk. After restarting your computer, switch to Windows desktop mode.Then double-click the RAIDXpert2
icon on the desktop to launch the RAID utility.
Step 1:
Enter the login ID and password (default: "admin"),
and then click Submit to launch AMD RAIDXpert2 .
Step 2:
In the
Disk Devices section, left-click your mouse
twice on the newly-added hard drive.
Step 3:
On the next screen, select
Assign as Global Spare
and click
Conirm
.
Step 4:
When the message "A rebuild task has resumed on.."
appears, click
OK to continue.
Step 5:
During the rebuild process, you can select the array
that is being built (displayed in red) in the Active
Volumes section to check the current progress. When
notiied that the rebuild is done, click
OK to complete.