Gigabyte G-MAX N411, Руководство пользователя

Страница: 33 / 110

2 How to Start
21
Replacing the Battery Pack
When your notebook computer G-MAX N411 estimates that the
battery only has enough charge to continue for a few minutes, it
will alert you with a battery low warning beep. If you are
consuming a lot of power by using the audio system, the PC Card
slots, the hard drives, and optical disk drive, your notebook
computer G-MAX N411 might run out of charge much sooner
than you expect. You should always respond to the battery low
indication by connecting to AC power or turning off your
notebook computer G-MAX N411, or suspending to disk. If you
do not do so, the notebook computer G-MAX N411 will
automatically suspend to disk and turn off. The contents of the
memory will store in the hard disk drive. You will be unable to
restart your notebook computer G-MAX N411 until you have
connected to the AC adapter or installed a charged battery. To
replace the battery pack, refer to the previous sections on
"Installing the Battery Pack" and "Removing the Battery Pack."
Be sure to save your data before replacing the battery
pack or connecting the AC adapter. Failure to do so can
result in data loss.
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type
recommended by the manufacturer. Dispose of used
batteries according to the manufacturer’s instructions.
Your notebook computer G-MAX N411 provides the most
convenient way to install the battery pack into your computer.
To install the battery, first orient the extended nose directed
toward the compartment, then following the sequence as shown
in the figure below.
1. Have a charged battery ready to install.
2. Shutdown your notebook computer G-MAX N411 and
disconnect the AC adapter.
3. Slide the battery release latches while pulling the battery from
the bay.