GIGA-BYTE TECHNOLOGY GA-MA78GM-US2H, Руководство пользователя

Страница: 33 / 100

Hardware Installation - 33 -
19) CLR_CMOS (Clearing CMOS Jumper)
Use this jumper to clear the CMOS values (e.g. date information and BIOS configurations) and
reset the CMOS values to factory defaults. To clear the CMOS values, place a jumper cap on the
two pins to temporarily short the two pins or use a metal object like a screwdriver to touch the two
pins for a few seconds.
•
Always turn off your computer and unplug the power cord from the power outlet before
clearing the CMOS values.
•
After clearing the CMOS values and before turning on your computer, be sure to remove
the jumper cap from the jumper. Failure to do so may cause damage to the motherboard.
•
After system restart, go to BIOS Setup to load factory defaults (select Load Optimized
Defaults ) or manually configure the BIOS settings (refer to Chapter 2, "BIOS Setup," for
BIOS configurations).
20) BATTERY
The battery provides power to keep the values (such as BIOS configurations, date, and time
information) in the CMOS when the computer is turned off. Replace the battery when the battery
voltage drops to a low level, or the CMOS values may not be accurate or may be lost.
•
Always turn off your computer and unplug the power cord before replacing the battery.
•
Replace the battery with an equivalent one. Danger of explosion if the battery is replaced
with an incorrect model.
•
Contact the place of purchase or local dealer if you are not able to replace the battery by
yourself or uncertain about the battery model.
•
When installing the battery, note the orientation of the positive side (+) and the negative
side (-) of the battery (the positive side should face up).
•
Used batteries must be handled in accordance with local environmental regulations.
You may clear the CMOS values by removing the battery:
1. Turn off your computer and unplug the power cord.
2. Gently remove the battery from the battery holder and wait for one minute.
(Or use a metal object like a screwdriver to touch the positive and
negative terminals of the battery holder, making them short for 5 seconds.)
3. Replace the battery.
4. Plug in the power cord and restart your computer.
Open: Normal
Short: Clear CMOS Values