Gibson MM516, Руководство пользователя

Страница: 55 / 57

MM516
User's Manual
55
Revision 1.4 7-8-2011
Hardware Description Manual
8.8 Bluetooth Qualified Design ID
Gibson has submitted End Product Listing (EPL) for the MM516 under Bluetooth QD ID: B018234. Manufacturers of
Bluetooth devices incorporating MM516 can reference the same QD ID number.
8.9 Industry Canada Certification
MM516 complies with the regulatory requirements of Industry Canada (IC), certification: IC: 9583A-MM516
Manufacturers of mobile, fixed or portable devices incorporating this module are advised to clarify any regulatory questions
and ensure compliance for SAR and/or RF exposure limits. Users can obtain Canadian information on RF exposure and
compliance from www.ic.gc.ca.
This device has been designed to operate with the antennas listed in Table 13 above, having a maximum gain of 4.9 dBi.
Antennas not included in this list or having a gain greater than 4.9 dBi are strictly prohibited for use with this device. The
required antenna impedance is 50 ohms. The antenna used for this transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
This device complies with Industry Canada licence-
exempt RSS standard(s). Operation is subject to
the following two conditions: (1) this device may not
cause interference, and (2) this device must accept
any interference, including interference that may
cause undesired operation of the device. Le présent appareil est conforme aux CNR
d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux
deux conditions suivantes : (1) l'appareil ne doit pas
produire de brouillage, et (2) l'utilisateur de l'appareil
doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en
compromettre le fonctionnement.
Under Industry Canada regulations, this radio
transmitter may only operate using an antenna of a
type and maximum (or lesser) gain approved for the
transmitter by Industry Canada. To reduce potential
radio interference to other users, the antenna type
and its gain should be so chosen that the
equivalent isotropically radiated power (e.i.r.p.) is
not more than that necessary for successful
communication. Conformément à la réglementation d'Industrie
Canada, le présent émetteur radio peut fonctionner
avec une antenne d'un type et d'un gain maximal
(ou inférieur) approuvé pour l'émetteur par Industrie
Canada. Dans le but de réduire les risques de
brouillage radioélectrique à l'intention des autres
utilisateurs, il faut choisir le type d'antenne et son
gain de sorte que la puissance isotrope rayonnée
équivalente (p.i.r.e.) ne dépasse pas l'intensité
nécessaire à l'établissement d'une communication
satisfaisante.
This radio transmitter
IC: 9583A-MM516
has been
approved by Industry Canada to operate with the
antenna types listed in Table 13 with the maximum
permissible gain and required antenna impedance
for each antenna type indicated. Antenna types not
Le présent émetteur radio
IC: 9583A-MM516
a été
approuvé par Industrie Canada pour fonctionner
avec les types d'antenne énumérés en Table 13 et
ayant un gain admissible maximal et l'impédance
requise pour chaque type d'antenne. Les types