F4 PLUS
UK
12
3 - INSTALLATION WARNINGS
4 - WARNINGS FOR THE USER
In the event of an operating fault or failure, cut the power upstream of the control unit and call Technical Service.
Periodically check functioning of the safety devices. Any repairs must be carried out by specialised personnel
using original and certified materials.
The product may not be used by children or persons with reduced physical, sensorial or mental capacities, or
lacking experience and knowledge, unless appropriately instructed. Do not access the circuit board for
adjustments and/or maintenance.
•
Before proceeding with installation, fit a differential magnetothermal switch with a maximum capacity of 10A
upstream of the system. The switch must guarantee omnipolar separation of the contacts with an opening
distance of at least 3mm.
•
To prevent possible interference, differentiate and always keep the power cables (minimum cross-section
1.5 mm²) separate from the signal cables (minimum cross-section 0.5 mm²).
•
Make the connections referring to the following tables and to the screen-printing on the board. Be extremely
careful to connect in series all the devices that are connected to the same N.C. (normally closed) input, and
in parallel all the devices that share the same N.O. (normally open) input.
•
Incorrect installation or improper use of the product may compromise system safety.
•
Keep all the materials contained in the packaging away from children since they pose a potential hazard.
•
The manufacturer declines all responsibility for improper functioning of the automated device if the original
components and accessories suitable for the specific application are not used.
•
When installation is complete, always carefully check proper functioning of the system and the devices used.
•
This instruction manual addresses professionals qualified to install “live equipment” and therefore requires
good technical knowledge and installation in compliance with the regulations in force.
•
Maintenance must be carried out by qualified personnel.
•
Before carrying out any cleaning or maintenance operation, disconnect the control unit from the mains.
•
The control unit described in this document may only be used for the purpose for which it was designed.
•
Check the intended end use and take all the necessary safety precautions.
•
Use of the products for purposes different from the intended use has not been tested by the manufacturer
and is therefore on full responsibility of the installer.
•
Mark the automated device with visible warning plates.
•
Warn the user that children or animals should not play or stand near the gate.
•
Appropriately protect the dangerous points (for example, using a sensitive frame).
WARNING: IMPORTANT SAFETY INSTRUCTIONS.
It is important to follow these instructions to safeguard persons.
Keep this instruction manual.
