Giant UG40-92TFTT-N2U, Руководство по эксплуатации и установке

Страница: 21 / 44

Giant Manual 21
Installa Ɵ on of Plumbing
A manual valve must be placed in the water inlet
connec on to the water heater before it is connected
to the water line. Unions may be used on both the
hot and cold water lines for future servicing and
disconnec on of the unit.
DO NOT

Do not introduce toxic chemicals such as those
used for boiler water treatment to the potable
water used for space hea ng.
MUST DO

The piping (including soldering materials) and
components connected to this appliance must be
approved for use in potable water systems.

Purge the water line to remove all debris and air.
Debris will damage the water heater.

If the appliance will be used as a potable water
source, it must not be connected to a system that
was previously used with a no potable water
hea ng appliance.

Ensure that the water fi lter on the water heater is
clean and installed.
Piping Requirements
Temperature & Pressure ‐ Relief Valve
Requirements
Install the Temperature & Pressure ‐ Relief (T&P) Valve
according to these instruc ons.
This water heater is provided with a properly cer fi ed
Temperature & Pressure ‐ Relief Valve by the
manufacturer.
An approved Temperature & Pressure ‐ Relief Valve is
required by the American Na onal Standard (ANSI
Z21.10.3) for all water hea ng systems, and shall be
accessible for servicing.
DO NOT

Do not plug the T&P valve and do not install any
reducing fi ngs or other restric ons in the relief
line. The relief line should allow for complete
drainage of the T&P valve and the line.

Do not place any other type valve or shut o ff
device between the relief valve and the water
heater.
MUST DO

The T&P valve must comply with the standard for
Relief Valves and Automa c Gas Shuto ff Devices for
Hot Water Supply Systems ANSI Z21.22 and /or the
standard Temperature, Pressure, Temperature and
Pressure Relief Valves and Vacuum Relief Valves,
CAN1
‐ 4.4 .

The T&P valve must be rated up to 150 psi and to
at least the maximum BTU/hr of the appliance.

The discharge from the T&P Valve should be piped
to the ground or into a drain system to prevent
exposure or possible burn hazards to humans or
other plant or animal life. Follow local codes.
Water discharged from the relief valve could cause
severe burns instantly, scalds, or death.

The Temperature & Pressure ‐ Relief Valve must be
manually operated once a year to check for correct
opera on.

The T&P valve should be added to the hot water
outlet line and near the hot water outlet according
to the manufacturer’s instruc ons. DO NOT place
any other type valve or shut o ff device between
the relief valve and the water heater.
INFORMATION

If a T&P discharges periodically, this may be due to
thermal expansion in a closed water supply
system. Contact the water supplier or local
plumbing inspector on how to correct this
situa on. Do not plug the relief valve.