Giant TRINITY ADVANCED SL -, Инструкция по эксплуатации

Страница: 12 / 18

23
Assembly Instruction
The Giant Trinity Advanced SL is using a traditional headset steering
combined with AeroDrive cockpit components.
Please closely follow the assembly instructions. Any failure in the assembly
could result in serious injury or death.
Caution
You need to have first proceeded to the part “AeroDrive size selection“
before starting executing this instruction.
Cable routing and cable length may be compromised if you have not
determined correctly your appropriate settings.
Warning
Grease all thread and screw before assembly.
Do not grease the stem and base bar contact area.
Do not grease the extensions and extension clamps contact areas.
1 Assemble the headset bearings, cups and cones as detailed at Headset
Instruction
2 Fix the base bar to the “upper stem
[10]” with the “base bar assembly
screw [13]”. Tighten this bolt to 4 Nm
CAUTION:
this bolt is not designed to clamp
firmly the base bar. Do not apply any
force to the base bar.
24
3 Assemble the extension set to the
“base bar [12]” as detailed at Armrest
and extensions
Armrest includes :
- extension clamps [4]
- extension rubber plugs [5]
- extensions [6]
- tear drop spacers (depending
your necessary adjustment) [7]
- extension clamp screws [14]
Tighten the extension clamp
screws [14] to 6Nm
4 Assemble the cables by routing them
into the “base bar [12]” as detailed at
Base bar cable routing
- assemble the brake cables
first with the brake levers
- assemble the index cables
with the shifters (either for
mechanical systems or
SHIMANO DI²)
5 Install the all cockpit set to the fork
steerer tube. Tighten slightly the
headset compression screw[8] in
addition to the steerer screws to
maintain the stem in a stable position.
Do not tighten the screws to the
recommended torque value yet.
6 Install front and rear brakes as well
as derailleurs
7 Route the cables through the fork
crown as detailed at Fork cable
routing