3
SP100W/SP100HK/SP200W/SP351W
-
Specifications
Consult the factory for special requirements that must be met if the
pump is to operate beyond one or more of the limits specified above.
PULLEY INFORMATION
Pulley selection and pump speed are based on
a 1725 RPM motor and “B” section belts. When
selecting desired GPM, allow for a ±5% tolerance
on pumps output due to variations in pulleys, belts
and motors among manufacturers.
1. Select GPM required, then select appropriate
motor and pump pulley from the same line.
2. The desired pressure is achieved by selecting
the correct nozzle size that corresponds with the
pump GPM.
HORSEPOWER INFORMATION
Horsepower ratings shown are the power re-
quirements for the pump. Gas engine power
outputs must be approximately twice the pump
power requirements shown above.
We recommend that a 1.1 service factor be speci-
fied when selecting an electric motor as the power
source. To compute specific pump horsepower
requirements, use the following formula:
(GPM X PSI) / 1450 = HP
Max.
Flow
Maximum
Pressure
Max.
Speed
Power
Required
Max
Temp
Plunger
Diameter
Stroke
Model
GPM
PSI
RPM
HP
°F
in
in
SP100W
11.2
1885
1420
14.6
160
1.02
0.79
SP100HK
11.2
1885
1420
14.6
195
1.02
0.79
SP200W
9.6
2175
1420
14.4
160
0.94
0.79
SP351W
6.7
3190
1420
14.7
160
0.79
0.79
Max.
Flow
Maximum
Pressure
Max.
Speed
Power
Required
Max
Temp
Plunger
Diameter
Stroke
Model
L/min
bar
RPM
kW
°C
mm
mm
SP100W
42.5
130
1420
10.9
70
26
20
SP100HK
42.5
130
1420
10.9
90
26
20
SP200W
36.2
150
1420
10.7
70
24
20
SP351W
25.2
220
1420
11.0
70
20
20
Common Specifications:
Crankcase Oil Capacity
.......
23.7 fl. oz. (0.7 L)
Inlet Ports ............................
(2) 3/4”
Discharge Ports ...................
(2) 3/4”
Crankshaft Mounting ...........Either Side
Shaft Rotation.....Top of Pulley Toward Fluid End
Weight .................................
41.9 lbs. (19 kg)
U.S Measurements
Metric Measurements
