Giant NeosGPS, Руководство по эксплуатации

Страница: 12 / 24

Enable GPS
Please disable GPS signaling in the event of indoor exercise to prevent recording less accurate ride
information.
Sensor Pairing
NeosGPS supports Bluetooth peripheral sensors. Please follow the steps below to pair.
1. Press to enter the setup page.
2. Press to select GPS, press and the GPS setup
page will display.
3. Press to select ON or OFF, press to validate the
selection made.
4. Once all settings have been made, press to
validate the selections made and exit back to the
main setup page and press to exit.
1. Press to enter the setup page.
2. Press to select SYNC, press and the SYNC setup
page will display.
3. Press to select HR or SP-CA, press to validate the
selection made.
4. Wake up the sensor by putting on the heart rate
belt, or pedaling the crank and wheel.
5. NeosGPS prompts the message "YES" when it
detects the sensor successfully; press to validate
the pairing; press to select "NO" and to cancel
the pairing and start scanning again.
6. Once all settings have been made, press to exit
the setup page.
12 Setup
Note: The sensor can be paired only in standby mode;
otherwise it will enter sleep mode to conserve battery
charge.
Note:
• Keep away from other Bluetooth sensors when pairing.
• After successful pairing, the NeosGPS smart sensor will auto connect to the device once it is awoken.