7
1) Loosen and remove
tension plugs (48) with a
36mm socket wrench.
TO CHECK VALVES
NOTE:
Always take time to lubricate all metal and non-metal parts with a light film of oil before reassembling. This step
will help ensure proper fit, at the same time protecting the pump non-metal parts (elastomers) from cutting and scoring.
44B 44A 45
2) Remove the support ring
(44B), O-ring (44A) and
tension spring (45).
3) Take out discharge valve
assemblies (46) by pulling
them upwards out of the
valve casing (43) with a
snap-ring tongs or any
other pull-off device. Then
remove inlet valves in the
same way.
4) Loosen valve seats (46A)
valve spring (46C), and
valve spring guide (46E)
from spacer pipe (46D)
by lightly hitting the valve
plate (46B) with a plas-
tic stick.Check sealing
surface and replace worn
parts. Reassemble with
new O-rings (44A) if pos-
sible and oil them before
installing.
5) Tighten up tension plugs
(48) to 107 ft.-lbs. (145
NM).
46A
46D
46B
46C
REPAIR INSTRUCTIONS
