Giant-Vac LBWJ85171KH, Руководство по сборке

Страница: 7 / 16

4
unit operation (cont.)
STARTING THE ENGINE (cont.)
•
Bracing unit with one hand on the upper handle and
one foot on the right rear tire, grasp recoil handle
and pull briskly. You may have to pull several times
before engine starts. (If engine fails to start within a
reasonable amount of time, discontinue and check
engine manual for further instructions.) Note: Do not
allow recoil rope to snap back into recoil; damage to
the rope or recoil could result.
•
After engine starts, move engine speed control to
approximately half and move choke control to open
“OFF” position.
TO SHUT ENGINE DOWN:
•
Move engine speed control to the slow “Turttle” position.
•
Allow engine to idle for 2-3 minutes before shutting down.
•
Turn engine kill switch to the “OFF” stop position.
•
Turn fuel valve to closed position.
IMPORTANT NOTE: If you experience problems with your engine that cannot be satisfactorily resolved by following the instructions
contained within the engine manual, contact your local engine dealer, or call the toll-free service number listed in the repair section of the
engine manual. All engine service, warranty or otherwise, is required to be performed by a manufacturer-authorized service center. The
equipment manufacturer is neither authorized nor responsible for any type of warranty engine service, nor is it equipped to perform any
such service.
BLOWER OPERATION
DANGER! DO NOT PASS BY OR STAND ON THE AIR DISCHARGE SIDE OF ANY
LEAF BLOWER WITH THE ENGINE RUNNING. HIGH VELOCITY DISCHARGE CAN
EASILY TURN HARMLESS DEBRIS INTO FLYING PROJECTILES.
DANGER! NEVER INSERT ANY BODY PART OR FOREIGN OBJECT INTO ANY
OPENING WHILE UNIT IS RUNNING. SERIOUS INJURY OR DEATH CAN RESULT.
GENERAL RULES TO OBSERVE BEFORE
AND DURING OPERATION:
•
Inspect your unit before each and every use. Check for worn, bent or broken components, loose fasteners,
low or flat tires, etc., and repair or replace prior to operation.
DO NOT OPERATE A DEFECTIVE UNIT –
SERIOUS INJURY OR DEATH CAN RESULT.
•
Clear the entire work area of all debris that could cause damage to or become entangled in the unit. Rocks
and large branches can wedge themselves between the impeller and housing, causing equipment damage
or personal injury. If in doubt, remove it.