GVTP GM48-R0103.1
3
unit assembly (cont.)
BATTERY INSTALLATION
*Important Note: Battery must be filled with acid before installation, as batteries are shipped dry for
safety purposes. Battery acid can be obtained from any auto parts store. Do not overfill.
•
Remove hardware securing battery box cover
(5:3) to battery box, and remove cover.
•
Fill battery (5:1) with acid*, then install battery
into battery box, making sure positive terminal
(‘+’) is toward front of mower, negative (‘-‘) is
toward rear.
•
Removing bolt from battery positive (‘+‘)
terminal (making sure not to lose nut plate
inside terminal), lay loose end of positive cable
(5:14 - attached to solenoid) on top of terminal
and fasten with same bolt as previously
removed. Tighten securely.
•
Removing bolt from battery negative (‘-‘)
terminal (making sure not to lose nut plate
inside terminal), lay loose end of ground cable
(5:6 -attached to left axle bearing top bolt) on
top of terminal and fasten with same bolt as
previously removed. Tighten securely.
•
Place rubber battery cover (5:2) over top of
battery.
•
Replace battery box cover, securing with same
hardware removed in previous step. Tighten
securely.
•
Inspect cables to make sure no contact is made
with moving parts.
Your mower is now ready to be started and checked for proper operation. Some minor
final adjustments may be required; see the Maintenance portion of this manual.
